ERROR: Belt - No signal from impulse transmitter (-XXX)

The machine belt motor was working, but the actual rotation of the belt was not detected. As the belt rotates, the switch detects the metal star, which should also rotate. Switch the operation of the machine to manual mode and turn on the belt conveyor.

• If the motor is running and the belt is stationary, indicates a mechanical problem. Open machine doors, and check inside. Check the belt tension, if something prevents belt from moving. Monitor the motor current if it is overloaded.
• If after switching on the motor, the belt rotates but the switch does not detect the movement of the star. It is necessary to bring the switch closer to the metal star to detect each of its transitions. The reach of the switch is ~2mm. If necessary, replace the inductive switch.

• If the switch really works, check in the status screens "MACHINE BELT". When the inductive switch is covered, the red cross change to green checkmark.

If you need additional information, call the Gostol TST service department.
Žarko Rejec
M: 00386 40 725 594
E: zarko.rejec@gostol-tst.eu