ERROR: Elevator - It cannot reach the desired speed (XXX)

The elevator motor was overloaded at startup. The frequency inverter protects the motor, because actual motor current is higher than allowed.

• Open the service cover and check the belt if it is stuck somewhere.
• Check the bottom of the elevator, the bottom should be clean and the abrasive sand must not cover the lower buckets.
• Clean the abrasive sand out from the elevator and turn it back on.

If you need additional information, call the Gostol TST service department.
Žarko Rejec
M: 00386 40 725 594
E: zarko.rejec@gostol-tst.eu