ERROR: Throwing wheel invertor - Overload (-TXX.X)

Overcurrent during the blasting: The abrasive valve should be manually adjusted with the bolt which regulates the flow of the abrasive through the valve of throwing wheel.

• If you turn this bolt Clockwise the current will go down (this is what you should do when overcurrent of throwing wheel motor appears).
• If you turn this bolt Counter Clockwise the current will go up.

WARNING
The operator must be careful, that a throwing wheel motor current is not over nominal value of motor.

If you need additional information, call the Gostol TST service department.
Žarko Rejec
M: 00386 40 725 594
E: zarko.rejec@gostol-tst.eu